Showing all 6 resultsSorted by popularity
Brand
- MECHBLOCK (6)
Price
Boards & Programmer
Mega 2560 ATmega2560-16AU Board without USB Cable
In stock
• 54 digital input / output terminals (14 of which have programmable PWM outputs).
• 16 analog inputs.
• 4 UARTs (hardware serial ports).
• 16 MHz crystal clock.
• Operating voltage: 6 ~ 12v.
USBASP ISP AVR Programmer
In stock
• Allows you to read or write the microcontroller EEPROM, firmware, fuse bits and lock bits
• Support for Windows, Mac OS X and Linux (will work on Windows 8.1)
• 5 KB/sec maximum write speed
• Software controlled SCK option to support targets with low clock speed (< 1.5MHz)
• The driver will work on both 32 and 64 bit platforms.
• On Linux And Mac OS X no kernel driver is required, just use AVRdude and specify the correct port.
ARM STM32 Arduino Minimum System Dev Board
In stock
• Frequency: 72 MHz
• Operating Voltage: 3.3 V
• Input Voltage (recommended): 3 V – 12 V
D1 ESP8266 Wifi Development Board
In stock
• Based on ESP-8266EX.
• Arduino compatible, using Arduino IDE to program.
• Support OTA wireless upload.
• Onboard 5V 1A Switching Power Supply (highest input voltage 24V).
• The direct use of Arduino IDE development, the same operation with Arduino UNO.
• Operating Voltage: 3.3V
• Digital I/O Pins: 11
• Analog Input Pins: 1
AVR ISP MKII compatible USB clone programmer
In stock
• Acceptable target power voltage 2~5V.
• Competitive with Window XP, Window 7, Window 8.
5V MAX II EPM240 CPLD Minimum System Core Board Development Board
In stock
• This CPLD chip is adapted to good low-cost CPLD/FPGA introduction.
• It can be used for product verification and development with Byte- and USB- downloader.
• Easy to use and installation: the module has JTAG, power interface and all connected pins you need, it can run after connecting to DC 5V power supply.