Showing 81–90 of 90 resultsSorted by popularity
Clearance
USBASP ISP AVR Programmer
In stock
• Allows you to read or write the microcontroller EEPROM, firmware, fuse bits and lock bits
• Support for Windows, Mac OS X and Linux (will work on Windows 8.1)
• 5 KB/sec maximum write speed
• Software controlled SCK option to support targets with low clock speed (< 1.5MHz)
• The driver will work on both 32 and 64 bit platforms.
• On Linux And Mac OS X no kernel driver is required, just use AVRdude and specify the correct port.
Flash Chip IC Test Clips Socket Adapter Programmer
In stock
• This item for sop8 chip ,such as 25c, 24c , 93c and so on .
• It can be used for the online in-circuit sop8 -dip8 adapter ,it is used for a sop8 chip programming that has been soldered on circuit board , it can online programming the sop8 chip , do not need take the chip of the circuit board , so it can save people’s time
AVR ISP MKII compatible USB clone programmer
In stock
• Acceptable target power voltage 2~5V.
• Competitive with Window XP, Window 7, Window 8.
8 Channel High Level Solid State Relay Module 250VAC 2A
In stock
• Power supply – 12VDC/160mA
• Trigger Voltage (VDC) – 12
• Switching Voltage (VAC) – 240@2A
• Isolation – Phototriac
5V MAX II EPM240 CPLD Minimum System Core Board Development Board
In stock
• This CPLD chip is adapted to good low-cost CPLD/FPGA introduction.
• It can be used for product verification and development with Byte- and USB- downloader.
• Easy to use and installation: the module has JTAG, power interface and all connected pins you need, it can run after connecting to DC 5V power supply.
SOIC8 SOP8 Flash Chip IC Test Clip IC Programming
In stock
• Connect SOP8-DIP8 adapter, suitable for SOP8 chips, such as 25, 24C, 93C and so on.
• It is used for SOP8 chip programming which has been soldered on the circuit.
• No need to take the chip off the board to save time and work.
• It can online programming the SOP8 chip.
M512 PIC ICD2 Programming Adapter PICKIT2 PICKIT3 Universal Programmer Seat
In stock
• Installing the microcontroller, 28-pin, 40-pin microcontroller left aligned 28/40P (A) This flag line short-circuit cap on the A position.
• The 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B position.
• The ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming the programming operation. Note: A separate program of the seat can not be programmed the chip is programmed functions.
HL-340 USB 2.0 to RS232 Serial port COM DB9 9 Pin Adapter Cable
In stock
₹299.00 Incl.GST / ₹253.39 Excl.GST• Side 1: Serial DB9 Male Com port RS232
• Side 2: USB Male pin Type A 2.0
• Supports remote wake up and power management
• Transfer Rate: 1Mbps
• Support all windows and Linux operating systems, driver available online for older versions
4 Digit PC ISA PCI Analyzer Diagnostic Test Post Card
In stock
₹1,699.00 Incl.GST / ₹1,439.83 Excl.GST• Compatible With Both ISA bus and PCI bus.
• Determine defects by difference sounds coding with build-in speaker.
• Fully compatible with any kind motherboards which has the PCI and ISA bus slot
• It can diagnosis the motherboard signal which show the problem of CPU, Memory, video card, etc. The POST code display is made up of a dual, dot matrix hexadecimal read-out that display’s Power On Self Test (POST) status codes.
SG90 9G Micro Servo Motor
In stock
• Operating voltage : 3.0V~ 7.2V
• Stall torque @4.8V : 1.2kg-cm
• Operating Speed @4.8v : 0.10sec/60°
• Servo Plug: JR
• High resolution
• Accurate positioning
• Fast control response
• Constant torque throughout the servo travel range
• Excellent holding power