Showing 81–85 of 85 resultsSorted by popularity
Clearance
5V MAX II EPM240 CPLD Minimum System Core Board Development Board
In stock
• This CPLD chip is adapted to good low-cost CPLD/FPGA introduction.
• It can be used for product verification and development with Byte- and USB- downloader.
• Easy to use and installation: the module has JTAG, power interface and all connected pins you need, it can run after connecting to DC 5V power supply.
M512 PIC ICD2 Programming Adapter PICKIT2 PICKIT3 Universal Programmer Seat
In stock
• Installing the microcontroller, 28-pin, 40-pin microcontroller left aligned 28/40P (A) This flag line short-circuit cap on the A position.
• The 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B position.
• The ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming the programming operation. Note: A separate program of the seat can not be programmed the chip is programmed functions.
HL-340 USB 2.0 to RS232 Serial port COM DB9 9 Pin Adapter Cable
In stock
₹299.00 Incl.GST / ₹253.39 Excl.GST• Side 1: Serial DB9 Male Com port RS232
• Side 2: USB Male pin Type A 2.0
• Supports remote wake up and power management
• Transfer Rate: 1Mbps
• Support all windows and Linux operating systems, driver available online for older versions
4 Digit PC ISA PCI Analyzer Diagnostic Test Post Card
In stock
₹1,699.00 Incl.GST / ₹1,439.83 Excl.GST• Compatible With Both ISA bus and PCI bus.
• Determine defects by difference sounds coding with build-in speaker.
• Fully compatible with any kind motherboards which has the PCI and ISA bus slot
• It can diagnosis the motherboard signal which show the problem of CPU, Memory, video card, etc. The POST code display is made up of a dual, dot matrix hexadecimal read-out that display’s Power On Self Test (POST) status codes.
SG90 9G Micro Servo Motor
In stock
• Operating voltage : 3.0V~ 7.2V
• Stall torque @4.8V : 1.2kg-cm
• Operating Speed @4.8v : 0.10sec/60°
• Servo Plug: JR
• High resolution
• Accurate positioning
• Fast control response
• Constant torque throughout the servo travel range
• Excellent holding power














